mayoreric.com

Morini Rubber Bits

As our Morini's enter the "vintage" class, many of their original rubber pieces are testing the limits of time and air on their chemistry. The following are parts that I have had reproduced from good originals. They are not NOS but rather reproductions. That being said, these are made of higher quality rubber than the originals and should last even longer. Contact eric at mayoreric daht com for more information.

View	Sidepanel Widgets Fit both the 3* and 500 models. Reproduced from the best remaining widget on my own 500. In stock. Price: $5.00 per set of four, US shipping included.
View	Moto Morini Grips These were stock on the old singles. Reproduced from a NOS pair provided by Luzzi Cesare. They are a snug fit on the twins, but I have had them on my 500. They may transport more vibration that modern grips, but they are the ultimate fashion accessory for your Morini. In stock. Contact me for information on when they might be available again. Price: $30.00 per pair, US shipping included.
View	500 Air Filter Elbows Fits the 500 model. These will not fit the 3*, because the 500 takes slightly larger carbs. (There has been some confusion on this, because both the 3* and 500 boots have "38" stamped on them.) As far as I know, NLM has the 3* elbows , and so I have not had them produced. These were duplicated from a good used (but not NOS) boot; therefore a scar from the hose clamp was reproduced as well. 1 pair only in stock. Price: $43.00 per pair, US shipping included. Reverse view.
View	Moto Morini Footpeg Rubbers These were stock on the old singles and the 3*. Reproduced from a NOS provided by Luzzi Cesare. Currently in stock. Price: $30.00 per pair, US shipping included. Reverse view.
View	Clutch Arm Cover Stock item on 3* and 500. Reproduced from a good original provided by a saintly Morini rider. Currently in stock. Price: $7.75 each, US shipping included.

Updated 09/15/2007